-
Manufacturers Instructions Should Be Read And Understood Prior To Any Installation With Installation Overseen By A Competent Person As Set Forth In 29 CFR 1926.450 (B)
-
Adjust - IT ™ Wall Bracing Is Designed To Be Used In Accordance With Industry Standards As Set Forth In The " Standards For Bracing Masonry Walls Under Construction" "Wall Bracing Handbook" And Applicable Local,State And/Or Federal OSHA Standards.
-
When Using Any Bracing System,We Recommend That Walls Under Construction That Have Experienced A Wind Load Event In Excess Of 40MPH Be Inspected Before Construction Proceeds.
-
We Recommend That Footers For Adjust-IT Back-To-Back Wall Bracing Jacks Follow Mud-Sill Standards As Defined In 29 CFR 1926.450 (B) & 1926.451 (C)(2)(iii)
-
OSHA Standards For Limited Access Zone/Restricted Zone As Set For In 29 CFR 1926.706 Must Be Adhered To.
-
Standard Personal Protective Equipment ( PPE ) Should Always Be Used When Working With Adjust - IT ™ Wall Bracing : Gloves,Hard-Hat,Safety Shoes & Any Other PPE Deemed To Be Appropiate For Individual Applications.
Adjust
- IT ™
Wall Bracing System:
While
Conventional Bracing Systems Rely On Tension With The Use Of Deadmen &
Cables To Anchor To The Wall
Adjust
- IT ™
Back
To Back Uses Compression With Two Triangles Of Steel On Each Side Of
The Wall.
